X-Control and firmware version history

From UfoWiki

(Updated June 4th, 2007)

[edit] X-Control

• V1.03
  • Among other things this fixed a bug in transferring the voltage- and current-parameters to the X-Base.
  • The instructions for connecting the X-3D have changed. Especially X-Base users should follow them in the exact sequence. Otherwise the sensor data will not display correctly.

• V1.02 (don't use anymore!)
  • Separate toolbar buttons for X-3D and X-Base
  • "simple" settings removed, only expert mode to edit the parameters (because the simple mode sliders don't work correctly with the X-Base yet)

• V1.01 (don't use anymore!)

• V1.00 (don't use anymore!)
  • Preinstalled version on the X-Base

[edit] X-3D-Firmware

• 2.0 for brushed motors and X-Base
  • Not usable for the X-3D on the china board!

• 1.1 - only modification: extended LED-codes to indicate bad sender settings.
  • Not usable for the X-3D on the X-Base!

• 1.0 for brushed motors and "china board"
  • Not usable for the X-3D on the X-Base!

[edit] X-Base-Firmware

• V1.03
  • Battery empty and nearly empty detection now work as planned.
  • Both can be configured again. This may have fixed the full-throttle-bug.

• V1.02 (don't use anymore!)
  • Sudden shutdown with almost full battery fixed
  • Channel assignment for "NC" channels fixed
  • Attention: Known bug: leave the battery-almost-empty warning at value 0, otherwise the X-3D initialisation will stop with a yellow LED lighting.

• V1.01 (don't use anymore!)
  • Bug in low-voltage-shutoff fixed

• V1.00 (don't use anymore!)
  • Bug in low-voltage-shutoff